My fear is that someone's going to advise a solution along the lines of "cut a surgical hole out the plaster and from there restructure the entire wall with your pinky and then masterfully skim over it and pretend nothing's happened." This is a bit beyond my skill, I think, so I might have to go for option 4 in this insistence. The plaster that goes over top and behind the lath strips dries hard and forms what’s called. Then plaster is applied on, oozing in between and behind the lathes. To build a plaster wall, wooden strips called lathes are nailed horizontally across the framing. Lots of people seem to advise this, but another miscellaneous man (on a forum this time) said that sometimes very old studs can crack when drilled into?ģ) Use butterfly/molly fixings to just go through the plaster/lath, close your eyes and hope that 6-8 of these across both brackets will be strong enough? To understand why plaster cracks, it helps to take a peek inside the plaster wall. A man in a shop told me this, but I haven't read it on any forums, so I'm not sure whether to trust this miscellaneous "man in a shop".Ģ) Find out where the vertical studs are using a cosmically strong magnet and just fix to this, as normal. Use extra long screws and fix the brackets to this. 1) Use an extra long drill bit to go right through to the brick, and then stick in an extra long raw plug that goes through and into the brick and sits facing out the plaster.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |